Filter
Top Products
49
Setup required when starting up
LS9-16/32 Owner’s Manual
4
Connections and setup
● Making HA settings for a group of eight
channels
Here’s how to access a popup window where you can
make HA settings for a group of eight channels.
1
Make sure that a mic or instrument is con-
nected to the INPUT jack (→ p. 41).
2
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1 HA popup button
B GAIN knob
3
Use the keys of the LAYER section and the
[SEL] keys of the channel module section
to select the channel for the INPUT jack you
want to control.
4
Move the cursor to the HA popup button or
GAIN knob in the SELECTED CH VIEW
screen, and press the [ENTER] key.
The HA/PATCH popup window will appear, allowing
you to adjust the HA gain, switch phantom power on/
off, and switch the phase in groups of eight channels.
This popup window shows the parameters for the eight
channels that include the channel you selected in step
2.
1 +48V button
B GAIN knob
C ø (phase) button
5
To adjust the HA gain, move the cursor to
the GAIN knob of the desired channel in the
window, and use the dial or the [DEC]/[INC]
keys.
The input level of the channel is shown by the level
meter located immediately to the right of the GAIN
knob in the screen.
6
To turn on phantom power for each chan-
nel, move the cursor to the +48V button in
the HA field of the screen, and press the
[ENTER] key.
The +48V button will turn on (red), and phantom
power will be supplied to the corresponding INPUT
jack.
7
To switch the phase of each channel
between normal and reverse phase, move
the cursor to the ø button in the HA field
and press the [ENTER] key.
The ø button will change from black to red, and the
phase of the corresponding channel will be reversed.
8
If you want to operate the HA of a channel
that is not currently shown in the popup
window, use the [SEL] key to select that
channel, and then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16.
1 2
1
2
3
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→
p. 194), you
can also access this popup window by pressing the
SELECTED CHANNEL section [HA GAIN] encoder.
HINT
• If you want to use phantom power, you must first turn ON the
+48V MASTER ON/OFF button located in the SYSTEM
SETUP screen.
NOTE