Filter
Top Products
57
HA (head amp) settings
5
Input channel operations
LS9-16/32 Owner’s Manual
Here’s how to make HA (Head Amp) settings such as phantom power on/off, gain, and phase for
each input channel.
1
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1 HA popup button
B GAIN knob
2
Use the LAYER section to select the desired
fader layer.
3
Press a [SEL] key in the channel module
section or ST IN section to select the input
channel that you want to operate.
4
If you only want to adjust the HA gain for
that channel, operate the SELECTED
CHANNEL section [HA GAIN] encoder.
You can obtain the same result by moving the cursor to
the GAIN knob in the SELECTED CH VIEW screen
and operating the dial or the [DEC]/[INC] keys.
5
If you want to edit detailed parameters such
as phantom power on/off and phase, move
the cursor to the HA popup button or GAIN
knob in the HA field of the SELECTED CH
VIEW screen, and press the [ENTER] key to
access the HA/PATCH popup window.
In the HA/PATCH popup window you can adjust the
HA gain, switch phantom power on/off, and switch the
phase for sets of eight channels. This popup window
shows the parameters for the eight channels that
include the channel you selected in step 3.
1 +48V button
B GAIN knob
C ø (phase) button
6
To adjust the HA gain, move the cursor to
the GAIN knob of the desired channel in the
window, and use the dial or the [DEC]/[INC]
keys.
The input level of the channel is shown by the level
meter located immediately to the right of the GAIN
knob in the screen.
7
To turn on phantom power, move the cursor
to the +48V button of the desired channel in
the window, and press the [ENTER] key.
The +48V button will turn on (red), and phantom
power will be supplied to the corresponding INPUT
jack.
HA (head amp) settings
1 2
1
2
3
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→
p. 194), you
can also access the above popup window by pressing the
SELECTED CHANNEL section [HA GAIN] encoder.
HINT
• If you want to use phantom power, you must first turn ON the
+48V MASTER ON/OFF button located in the SYSTEM
SETUP screen.
NOTE