Filter
Top Products
22
Setup Switch Settings
The WX5 has 16 DIP switches which can be used to set up
a range of important basic parameters. These switches are
not intended for frequent use, but rather to set up the WX5
to match your individual playing requirements. Read the
descriptions below carefully before changing the setup
switch settings.
● Remove the rubber switch cover, and use a small screwdriver or similar imple-
ment to change the switch settings as required.
● The switches are OFF when flipped to the left, and ON when flipped to the
right. All switches are OFF when the WX5 is initially shipped.
1-1
1-2
1-3
1-4
1-5
1-6
1-7
1-8
2-1
2-2
2-3
2-4
2-5
2-6
2-7
2-8
Vel
Win
Win
LIP
LIP
LIP
LIP+
Tr ns
Fing
Fast
Hi ct
Whl
nrm fix
nrm hrd
nrm wide
P/B M/W
off on
tht loos
B/C EXP
VOL
A C
B Fl
off on
PB gen
MW filt
off on
● Switch 1-1 (Vel) - Velocity
Determines whether the key-on velocity will be fixed or
controlled by wind pressure.
SW 1-1 Setting
OFF Variable (fixed time delay)
ON Fixed (velocity - 100)
● Switch 1-2 & 3 (Win) - Wind Sensor to MIDI Data
Specifies the type of MIDI data via which the WX5 wind
data will be transmitted.
SW 1-2 SW 1-3 Setting
OFF – Breath Controller
(control change #2)
ON OFF Expression
(control change #11)
ON ON Volume (control change #7)
● Switch 1-4 (Win) - Wind Curve
Determines the relationship between breath pressure and
the output MIDI volume data.
SW 1-4 Setting
OFF Normal
ON Hard (requires considerable breath pressure to
produce maximum volume)
● Switch 1-5 (Lip) - Tight Lip/Loose Lip Mode
Selects the Tight Lip or Loose Lip playing mode. In the
Tight Lip mode pitch can be bent up and down via lip
pressure, but in the Loose Lip mode pitch can only be
bent upward via lip pressure (page 11).
SW 1-5 Setting
OFF Tight Lip
ON Loose Lip
● Switch 1-6 (Lip) - Lip Data Range
Determines the range of data which can be produced via
lip control, depending also on the setting of Switch 1-7
(Lip Data), below.
SW 1-6 Setting
OFF Normal
ON Wide (greater range)
Normal Wide
Reed Open -16 -64
Center 0 0
Maximum +32 +63
Normal Wide
Reed Open 0 0
Maximum +32 +63
Loose Lip Mode
When Lip Data is set to “Modulation Wheel”
Normal Wide
Reed Open 48 0
Center 64 64
Maximum 96 127
Normal Wide
Reed Open 0 0
Maximum 64 127
Loose Lip Mode
When Lip Data is set to “Pitch Bend”
Tight Lip Mode
Tight Lip Mode
•
When using the WX5 with a tone generator which does
not have a WX IN connector, be sure to set the SW1-
1(Vel) switch ON so that a fixed velocity value is transmit-
ted, and set the SW1-2(Win) and SW1-3(Win) switches
so that MIDI expression control (SW1-2 ON, SW1-3 OFF)
or volume control (SW1-2 ON, SW1-3 ON) is transmitted.