Filter
Top Products
30
YDP-121
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given
below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
ZOpen the box and remove all the parts.
On opening the box you should find the parts shown in the illustration above. Check to make sure that all the required parts
are provided.
1
• Bundled pedal cord inside
• 6 x 35 mm round-head screws x 4 1
A
B
C
D
D
● Cord holders x 2 ● AC power cord
106
• 4 x 10 mm round-head screws x 2 2
• 4 x 16 mm tapping screws x 4 3
• 6 x 16 mm flat-head screws x 4 4