Filter
Top Products
34
YDP-121
MVoltage Selector and AC power cord.
Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a “minus” screwdriver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially
shipped.
After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adap-
tor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area.
CAUTION
• An improper voltage setting can cause serious damage to the YDP-121 or result in improper operation.
<Set the adjuster.
For stability, an adjuster is provided on the bottom of the pedal box (C). Rotate the adjuster until it comes in firm contact with
the floor surface. The adjuster ensures stable pedal operation and facilitates pedal effect control. If the adjuster is not in firm
contact with the floor surface, distorted sound may result.
■ After completing the assembly, please check the following.
• Are there any parts left over?
➔ Review the assembly procedure and correct any errors.
• Is the YDP-121 clear of doors and other movable fixtures?
➔ Move the YDP-121 to an appropriate location.
• Does the YDP-121 make a rattling noise when you shake it?
➔ Tighten all screws.
• Does the pedal box rattle or give way when you step on the pedals?
➔ Turn the adjuster so that it is set firmly against the floor.
• Is the pedal cord inserted securely into the socket?
➔ Check the connection.
• If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws.
• A voltage selector is provided in some areas.
7 8
C
240
127
110
220
110