Filter
Top Products
Keyboard Stand Assembly
• Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the se-
quence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each
unit.
• To disassemble, reverse the assembly sequence given below.
ZOpen the box and remove all the parts.
On opening the box you should find the parts shown in
the illustration above. Check to make sure that all the
required parts are provided.
1
• Bundled pedal cord inside
• 6 x 35 mm round-head screws x 4 1
• 4 x 10 mm round-head screws x 2 2
• 4 x 20 mm tapping screws x 4 3
• 6 x 16 mm flat-head screws x 4 4
A
B
C
D
D
18