Filter
Top Products
21
• Use the vinyl tie that was removed from the bundled pedal
cord in step X to tie up any slack in the pedal cord.
6
• 6 x 16 mm flat-head screws 4
D
A
A
A
Align the holes on the bottom panel of the main unit with
the holes in the brackets on the side panels (also center
the main unit to produce equal clearance on the left and
right sides, as shown in the illustration), then screw in and
securely tighten the four 6 x 16 millimeter flat-head
screws 4.
• Do not hold the keyboard in any position other than the position
shown in the above illustration.
• Fingers can become pinched between the main unit and the rear or
side panels, be extra careful so as not to drop the main unit.
NConnect the pedal cord.
The pedal cord from the pedal box must be plugged into
the corresponding connector in the main unit. The plug
only goes in one way (the lug on the connector should
face the rear of the main unit, as shown in the illustra-
tion), so don’t try to force it in the wrong way around.