Filter
Top Products
24
YPP-200
Using the User Song Recorder
Start Recording.................................................................................................
Recording will begin automatically as soon as you play a note on the
keyboard or press the SONG [START/STOP] button. The current
measure number will appear on the display while recording.
• A footswitch connected to the SOFT jack can be assigned to function as
a start/stop switch for song recording with the “Soft Pedal Mode”
described on page 29.
• If the metronome was on when you started recording, you’ll be able to
keep time with the metronome while recording, but the metronome sound
will not be recorded.
• You can record up to a maximum of about 10,000 notes on the YPP-200,
depending on pedal usage and other factors. The record track indicator
will begin to flash when recorder memory is almost full. If the memory
becomes full during recording, “
FUL
” will appear on the display and
recording will stop automatically. (All recorded data up to that point will be
retained.)
Stop Recording .................................................................................................
Press either the [REC] or SONG [START/STOP] button to stop
recording.
The indicator of the recorded track will glow green to indicate that it
now contains data.
Erasing a Single Track ..............................................................................
All data can be erased from either of the recorder’s tracks by engag-
ing the record mode, selecting the track you want to erase, and then
pressing the SONG [START/STOP] button twice without recording
any data.
Changing the Initial Settings..............................................................
The initial voice, tempo, reverb type, reverb depth, and effect settings
made in step 1 of the recording procedure are actually recorded by the
YPP-200.
These initial settings can be changed after the recording is finished by
pressing the [REC] button to engage the record ready mode, pressing the
appropriate track button, making the required changes, and then pressing
the [REC] button again to exit from the record ready mode and register
the changes.
If you do this, be careful not to press the SONG [START/STOP]
button or a key on the keyboard, either of which will start recording and
erase all previous recorded data on the selected track.
It is possible to cancel the operation even after changes have been
made: change tracks and then press the [REC] button to exit from the
record mode (this also cancels data for the entire song).
• The following data for initial settings cannot be changed: “Dual balance
(F3)”, “Dual detune (F3)” or “Dual octave shift (F3)”.
Press twice.