1-4
LED Status Description
OFF
The link has not been established, either
nothing is connected to the port, or there is a
problem:
z Check that the attached device is powered
on.
z Check that the cable or fiber is the correct
type and is not faulty.
z For fiber connections, ensure that the
receive (RX) and transmit (TX) cable
connectors are not swapped.
If these checks do not identify the cause of the
problem, it may be that the unit or the device
connected to the port is faulty. Contact your
supplier for further advice.
Yellow The port is in full duplex mode.
Duplex
10/100/1000BAS
E-T port
OFF
The port is not connected, or is in half duplex
mode.
Green The SFP module is inserted.
Module Active SFP port
OFF
The SFP module is not inserted or is not
recognized.
Green
The port is supplying power to the device
connected to it.
PoE Power (Only supported by
Baseline Switch 2426-PWR Plus)
OFF
The port is not supply power to the device
connected to it or not connected.
System Specifications
Table 1-3 contains the system specifications of the Switch.
Table 1-3 System specifications of the Switch.
Specification 2226-SFP 2426-PWR 2250-SFP
Physical dimensions
(H×W×D)
44 mm×440 mm×170
mm
44 mm×440 mm×238
mm
44 mm×440 mm×238
mm
Weight 1.6 kg 3.2 kg 2.9 kg
Console port 1 1 1
Ethernet port 24
24 (Each port can
provide a power
supply of 25 W)
48
Gigabit Combo port 2 2 2
AC Input voltage
Rated voltage range:
100–240V AC, 50/60
Hz
Rated voltage range:
100–240V AC, 50/60
Hz
Rated voltage range:
100–240V AC, 50/60
Hz
Power consumption (full
load)
17 W 205 W 26 W
Operating temperature 0°C to 40°C (32°F to 113°F)
Storage temperature –10°C to +70°C (14°F to 158°F)
