24 CHAPTER 2: INSTALLING THE SWITCH
To fit another unit:
1 Rest the second unit on the top of the clip and align it with the front of
the unit below.
2 Press down gently on the unit to secure in onto the clip, ensuring the
fastening pieces fit into the slots on the unit below, as shown in Figure 5
(picture 2).
Figure 5 Stacking Your Units together
Wall-mounting There are two slots on the underside of the Switch that can be used for
wall mounting. The Switch must be mounted with the LEDs facing
upwards.
When wall mounting the unit, ensure it is within reach of the power
outlet.
When wall mounting the unit, ensure that the rubber feet are not fixed.
Mounting
Instructions for
Cement Walls
To wall mount the unit on a cement wall, follow these instructions:
1 Make two holes 150 mm (5.9 in.) apart and insert two nylon or similar
screw anchors that are suitable for the wall construction.
2 Fix two suitable screws into the anchors, leaving their heads 3 mm
(0.12 in.) clear of the wall surface. The screws should be at least 30 mm
(1.2 in.) long.
3 Remove any connections from the Switch and locate it over the screw
heads. When in line, gently push the Switch on to the wall and move
downwards to secure.
1
Fastening
Piece
2
Fastening
Piece
