116 CHAPTER 8: CONFIGURING THE DUAL 56K LAN MODEM FOR DIAL-IN SUPPORT
Figure 68 Dial-in Users Parameters Screen
3 In the Name field, enter a unique name to designate this dial-in user.
4 In the Password field, enter a password to verify access when this user dials into
the LAN Modem.
5 In the Type of Use field, select the scenario for which your dial-in situation applies:
■ Choose Single-User Dial-in if this user will be accessing the LAN Modem
from a regular analog modem or second analog LAN Modem on which
attached workstations can share a single IP address using NAT.
■ Choose LAN Modem Site-to-Site if this user will be dialing in from another
LAN Modem which is being configured as both a server-side and client-side
device (for “peer-to-peer” networking).
■ Choose Advanced if this user will be accessing the LAN Modem from a
router other than a LAN Modem. This scenario requires that all IP addresses
be statically configured, and should be configured by your MIS
administrator.
6 In the Idle Timer field, enter the length of inactivity before the LAN Modem drops
the incoming call. By default this value is 900 seconds (15 minutes).
