140 APPENDIX A: SAFETY INFORMATION
Important Safety
Information
■ Installation and removal of the unit must be carried out by qualified
personnel only.
■ The unit must be earthed (grounded).
■ The unit must be connected to an earthed (grounded) outlet to comply
with European safety standards and EMC standards.
■ Power Cord Set
This must be approved for the country where it is used:
■ This unit operates under SELV (Safety Extra Low Voltage) conditions
according to IEC 950. The conditions are only maintained if the
equipment to which it is connected also operates under SELV conditions.
■ The appliance coupler (the connector to the unit and not the wall plug)
must have a configuration for mating with an EN60320/IEC320 appliance
inlet.
■ The socket outlet must be near to the unit and easily accessible. You can
only remove power from the unit by disconnecting the power cord from
the outlet.
UK ■ The supply plug must comply with BS1363 (3-pin 13
amp) and be fitted with a 5A fuse which complies with
BS1362.
■ The mains cord must be <HAR> or <BASEC> marked
and be of type HO3VVF3gO.75 (minimum).
Europe ■ The supply plug must comply with CEE 7/7
(“SCHUKO”).
■ The supply plug must comply with CE123-16/VII.
USA and
Canada
■ The cord set must be UL-approved and CSA certified.
■ The minimum specification for the flexible cord is:
No. 18 AWG
Type SV or SJ
3-conductor
■ The cord set must have a rated current capacity of at
least 10A.
■ The attachment plug must be an earth-grounding type
with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A,
250V) configuration.
Denmark ■ The supply plug must comply with section 107-2-D1,
standard DK2-1a or DK2-5a.
Switzerland ■ The supply plug must comply with SEV/ASE 1011.
