A SERVICE OF

logo

57 of 68
6-1 Operating Mode and Error Display Messages
Figure 5: Display Messages, Operational and Errors
Message Type
Display Presentation
Description
Normal Autotune
Autotuning [ ]
Normal Running
Running [ ]
Running. (High Heat and Cool shown is Normal)
Normal RampSoak
Rampsoak [ ]
Alarm
Alarm1/2 [LoFluid LVL]
This Indicates Alarm Low Fluid Level
Alarm
Alarm1/2 [Lo Pressure]
This Indicates Alarm Low Pressure
Alarm
Alarm1/2 [High LEVEL]
This Indicates Alarm High Fluid Level
Alarm
Alarm1/2 [Process]
This Indicates Alarm Temperature Process
Exceeded
Alarm
Alarm1/2 [Deviation]
This Indicates Alarm Temperature Deviation
Exceeded
Alarm (Major Fault)
Alarm1/2 [SafetyTherm]
This Indicates Alarm Safety Thermostat Alarm
Input Detected
Alarm [Major Fault)
Alarm1/2 [SensorRange]
This Indicates Sensor Over-range or beyond range
of the unit.
Alarm [Major Fault)
Alarm1/2 [Sensor Open]
This Indicates Delivery, Return or Remote Sensor
Open or Not Connected to the input connector
Alarm (Major Fault)
Alarm1/2 [WeldContact]
This Indicates Heater Weld Contact Input
Detected
Alarm (Major Fault)
Alarm1/2 [Pump Fail]
This Indicates Pump Phase Error Input Detected
Alarm
Alarm1/2 [Event]
This Indicates Ramp Soak Segment Event Alarm
Alarm
Alarm1/2 [Lo Flow]
This Indicates Flow Sensor Alarm Low Flow
Alarm
Alarm1/2 [Hi Flow]
This Indicates Flow Sensor Alarm High Flow
Tank Fill
Running [TankFill]
Automatic Tank Fill Mode Active
Prom/Signature
Error Alternating with
Loading Factory defaults
RS Comm Card Installed in DAC Card Slot
Temp= -44° F
Sensor set to RTD in Secure Menu, JMR 1 or 2 set
for T/C Input