2 –Pump 18-Station Controllers Chapter 3: Installation 15 of 44
Setting the Number of Stations and the Number of Pumps
Figure 1: Default “Station Status” Screen Before Setup
1. At the “Station Status” screen (Figure 1), touch the MENU button. The “Main Menu”
screen opens.
2. Once in the Main Menu Screen, press the SYSTEM SETUP button. The “System
Setup” screen opens.
Figure 2: “System Setup” Screen
3. At the “System Setup” screen, (Figure 2), touch STATIONS ACTIVE, or PUMPS
ACTIVE. A keypad pops up (Shown below) once that particular button is pressed.
This screen will allow you to configure the number of stations (1-18) and pumps (1-
2) to be controlled by the system.
Setting Values
Enter the values you would like to set in the screen by pressing the number keys. Press ENT
(Enter) when you are finished to set the new values or CLR (Clear) to erase the current values
and reenter new ones. To set the values in the next field, press ENT (Enter) to close the
screen shown above. Then select the next number field to enter new values.
4. Once the values have been set in this screen for “Stations Active” and “Pumps
Active” press the MORE button to set the Alarm Silence feature.
