ReadySystem 1U Users Guide 1
Chapter 1 Setting Up the ReadySystem 1U
About the ReadySystem 1U
The ReadySystem™ products are intended for users of turn-key embedded systems, who prefer long
lifecycle, configuration controlled computers over desktop grade systems with frequently changing
motherboards. ReadySystem models feature the ReadyBoard single board computer (SBC), from the
400 MHz Intel Celeron® CPU to the Intel 1.4 GHz Pentium® M 738 CPU. The desired operating
system (OS) is pre-loaded onto the internal 40 GB (or greater) 2 ½" hard disk drive (HDD). Just load
your application software and you are ready to use your system applications.
Using this Guide
This guide provides the most efficient way to set up your ReadySystem 1U with your desired Operating
System (OS). The instructions provided in this guide include:
• Removing the ReadySystem™ 1U from the shipping container and inventorying the accessories
• Connecting peripherals to the ReadySystem 1U
• Powering up the ReadySystem 1U
Information not provided in this Users Guide includes:
• ReadyBoard model specifications
• Environmental requirements
• ReadyBoard model connector/pin numbers and definitions
• Operating System programming, or operating instructions
NOTE Refer to the specific Ampro OS manual or the OS manufacturer's
manual for instructions when using the OS software.
Requirements
The following peripherals and devices are needed to make full use of the ReadySystem 1U.
• Peripherals (Customer provided):
♦ PS/2 Keyboard and PS/2 Mouse
♦ CRT (VGA) Monitor
• Power Cord and AC-DC Adapter (Ampro or Customer provided):
♦ AC to DC (+12 VDC or +24 VDC) Brick Power Adapter (with screw-type mating connector)
CAUTION The ReadySystem 1U only accepts 12VDC or 24VDC power. Voltages other than 12
or 24 will damage the system.
• Optional Devices/Connections (Customer provided):
♦ Ethernet (LAN) connection
♦ USB Devices, including a keyboard and mouse
