A SERVICE OF

logo

This is the recommended sequence for adding products to produce your slurry.
1. Start with approximately 2/3 to 3/4 of the total water volume.
2. Add dyes and/or colorants.
3. Add water soluble products, such as Orthene or Ag-Strep.
4. Add wettable powders, such as Guacho 75 ST or Lorsban 50 SL.
5. Add any water-dispersible granular products.
6. Add water based owables.
7. Add emulsiable concentrates or concentrated emulsion products.
8. Add oil based owables, such as DiPel ®4L.
9. Polymeric and/or coatings additives are added last (special rules may apply).
10. Use the water balance for container rinsing.
Note:
The 8 & 8 Rule says 8 ounces of powder will displace 8 uid
ounces of water.
23.0
Slurry Preparation