12
DUAL-PORT NETWORK POWER SWITCH
2.4 Back Panel
Figure 2-2. Back panel.
1. Power inlet: Supplies power for the Dual-Port Network Power Switch’s
command functions and the two switched plugs.
2. Circuit breaker: SWI081A: 115 VAC, 15 amps or SWI081AE: 230 VAC,
10 amps.
3. Master power switch: This switch must be in the on position in order for the
Dual-Port Network Power Switch to function. This switch is not used to set the
on/off status of the switched outlets.
4. Network port and activity indicator: An RJ-45 Ethernet port for connection to
your TCP/IP network. To communicate via network, you must first specify the
IP Address, Subnet Mask, and Gateway Address as described in Section 4.6.
5. Switched AC outlets: SWI081A: Each outlet can switch up to 15 amps. Total
for both outlets must not exceed 15 amps. SWI081AE: Each outlet can switch
up to 10 amps. Total for both outlets must not exceed 10 amps.
6. Option switches: A bank of four DIP switches which select default settings for
the baud rate and other features.
7. Modem port: A male RS-232, DB9 connector, DTE configuration. For
connection to an external modem.
8. Console port: A male RS-232, DB9 connector, DTE configuration. For
connection to a local PC.
9. Default button: Resets the unit to default settings as described in Section 3.7.
12 3 4
56789
