16
DUAL-PORT NETWORK POWER SWITCH
3.7.1 D
EFAULT
P
ARAMETERS
O
PTION
This method allows default parameters to be set without affecting the on/off status
of the Dual-Port Network Power Switch’s two switched plugs. To reset the unit to
default parameters, proceed as follows:
1. Access the Dual-Port Network Power Switch’s command mode (see
Section 5.1).
2. At the TPS> command prompt, type /G and press [Enter]. The General
Parameters menu will appear.
3. From the General Parameters menu, type A and press [Enter]. If command
confirmation is enabled, the unit will display a “Sure?” prompt. Type Y and
press [Enter] to proceed with the reset procedure. After a brief pause,
parameters will be reset to default values.
NOTE
If the default parameters function is invoked via the network port, the IP
address will not be reset. If this function is invoked via the console port
or modem port, the IP Address will be reset.
3.7.2 D
EFAULT
B
UTTON
(L
OCAL
)
Typically, this method is used when devices have not been connected to the Dual-
Port Network Power Switch and you have immediate access to the installation site.
NOTE
This method will temporarily switch all plugs off.
Set the master power switch to the OFF position. Press and hold the Default
button, located on the instrument back panel. Place the master power switch in the
ON position. Wait about 5 seconds, then release the Default button.
