22
DUAL-PORT NETWORK POWER SWITCH
7. Disconnect Timeout: Determines how long the Dual-Port Network Power
Switch will wait for additional commands. Type 7, press [Enter], and follow
the instructions in the submenu. (Default determined by option switch 4;
Factory setting = 2 Min)
8. Command Confirmation: When enabled, the Dual-Port Network Power
Switch will display a “Sure?” prompt before completing the /T, /X, /R,
/BOOT, /ON, /OFF, /D, and “A” commands, and will also display the
System Status screen after commands are successfully completed. When
disabled, the “Sure?” prompt is suppressed, and the Status screen is not sent
when commands are complete. (Default = On.)
9. Automated Mode: When enabled, the Dual-Port Network Power Switch will
execute the /ON, /OFF, /BOOT, /D, and /X commands without displaying
the confirmation prompt, status screen, or confirmation messages. This allows
the Switch to be controlled by a device that generates commands to control
power switching without human interaction. For more information, please
refer to Section 5.5. (Default = Off.)
NOTE
When this option is enabled, Dual-Port Network Power Switch password
security functions are disabled, and users are able to access system
level menus and control both plugs without entering a password.
10. Button Mode: Enables/disables the manual plug control buttons on the Dual-
Port Network Power Switch front panel. When enabled, the Switch’s two
switched plugs can be toggled on and off by pressing and holding the manual
control button for approximately one second. When disabled, the manual
control buttons will have no effect. (Default = On.)
A. Default Parameters: Resets the Dual-Port Network Power Switch to the default
values specified by the option switches. In addition, all menu-selected
parameters, including port names and passwords, will be lost. If command
confirmation is disabled, the “Sure?” prompt will not be sent.
NOTE
If the Default Parameters function is invoked via the network port,
the IP address is not reset. If this function is invoked via the console
port or modem port, the IP address will be reset.
After defining the general parameters, press [Esc] to exit from the General
Parameters menu.
