vmo2006-014-044_a
TYPICAL
1. Airfilterhousing
2. Drain tube
3. Clamp
NOTE: If vehicle is used in dusty area,
inspect more frequently than specified
in MAINTENANCE CHART.
If liquid/deposits are found, squeeze
and remove the clamp. Pull drain tube
out and empty it.
CAUTION: Do not start engine
when liquid/deposits are found
in the drain tube.
When liquid/deposits are found, the
air filter must be inspected/dried/
replaced depending on its condition.
Oil Change and Oil
Strainer Cleaning
Oil change should be done with a
warm engine.
ƽ
WARNING
The engine oil can be very hot. In
order to avoid potential burns, do
not remove the engine drain plug
or the oil strainer cover if the en-
gine is hot. Wait until engine oil is
warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
vmo2006-014-035_a
LH SIDE UNDERNEATH CVT COVER
1. Oil drain plug
Unscrew the oil strainer cover.
Allow enough time for oil to flow out
of oil strainer hole.
vmo2006-014-036_a
RH SIDE OF ENGINE
1. Oil strainer cover
Remove oil strainer and spring.
To clean oil strainer, use a solvent then
dry with compressed air.
ƽ
WARNING
Always wear eye protector. Chem-
icals can cause a rash break out
andaninjurytoyoureyes.
NOTE: Check cover O-ring and replace
it if necessary.
Wipe out any oil spillage on engine.
100
_____________________
