– Check location of controls and en-
sure they work properly.
– Verify if steering operates freely.
– Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
– Activate the brake levers and brake
pedal to make sure the brakes fully
apply. Levers and pedal must fully
return when released.
– Ensure transmission lever is work-
ing then reset in NEUTRAL position.
– Check drive chain for adjustment
and lubrication.
– Check sprockets for wear and dam-
ages.
– Check tightening of rear axle fasten-
ers.
– Check swing arm, if any lateral play
is detected DONOTUSETHEVE-
HICLE.
– Check fuel, oil and coolant levels.
– Check for oil leaks on the engine
and gearbox.
– Ensure fuel valve is in fully open
position (ON).
– Clean headlamps and taillight.
– Ensure front access compartment
cover is properly latched.
– Ensure seat is properly latched.
– If you transport cargo, respect load
capacity.
– If you are pulling a trailer or other
equipment, ensure it respects the
tongue capacity and towing capac-
ity. Ensure trailer is properly se-
cured to hitch.
– Look and feel for loose parts while
engine is off. Check fasteners.
– Ensure the path of travel is free of
persons and obstacles.
– Check operation of ignition switch,
engine start button, engine stop
switch and headlamps.
– Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Can-Am dealer as necessary.
____________
SAFETY INFORMATION
___________
41
