Implementing IS-IS on Cisco IOS XR Software
How to Implement IS-IS on Cisco IOS XR Software
RC-121
Cisco IOS XR Routing Configuration Guide
Step 5
default-information originate [route-map
map-name
]
Example:
RP/0/RP0/CPU0:router(config-isis-af)#
default-information originate
(Optional) Injects a default IPv4 or IPv6 route into an IS-IS
routing domain.
• The route-map keyword and map-name argument
specify the conditions under which the IPv4 or IPv6
default route is advertised.
• If the route-map keyword is omitted, then the IPv4 or
IPv6 default route is unconditionally advertised at
Level 2.
Step 6
redistribute isis
instance
[level-1 | level-2 |
level-1-2] [metric
metric
] [metric-type
{internal | external}] [policy
policy-name
]
Example:
RP/0/RP0/CPU0:router(config-isis-af)#
redistribute isis 2 level-1
(Optional) Redistributes routes from one IS-IS instance into
another instance.
• In this example, an IS-IS instance redistributes IS-IS
instance 2 routes into its Level 1 area.
Step 7
summary-prefix [
address
/
prefix-length
] [level
{1 | 2}]
or
summary-prefix [
ipv6-prefix
/
prefix-length
]
[level {1 | 2}]
Example:
RP/0/RP0/CPU0:router(config-isis-af)#
summary-prefix 10.1.0.0/16 level 1
or
RP/0/RP0/CPU0:router(config-isis-af)#
summary-prefix 3003:xxxx::/24 level 1
(Optional) Allows a Level 1-2 router to summarize Level 1
IPv4 and IPv6 prefixes at Level 2, instead of advertising the
Level 1 prefixes directly when the router advertises the
summary.
• This example specifies an IPv4 address and mask.
or
• This example specifies an IPv6 prefix, and the
command must be in the form documented in RFC 2373
in which the address is specified in hexadecimal using
16-bit values between colons.
• Note that IPv6 prefixes must be configured only in the
IPv6 router address family configuration submode, and
IPv4 prefixes in the IPv4 router address family
configuration submode.
Step 8
maximum-paths
route-number
Example:
RP/0/RP0/CPU0:router(config-isis-af)#
maximum-paths 16
(Optional) Configures the maximum number of parallel
paths allowed in a routing table.
Step 9
distance
weight
[
address
/
prefix-length
[
route-list-name
]]
Example:
RP/0/RP0/CPU0:router(config-isis-af)# distance
90
(Optional) Defines the administrative distance assigned to
routes discovered by the IS-IS protocol.
• A different administrative distance may be applied for
IPv4 and IPv6.
Command or Action Purpose
