408 | AccessPoints(APs) DellPowerConnectW-SeriesArubaOS6.2 | User Guide
AP Model Freqency Band Antenna Port
5GHz Upper Right
W-AP134 2.4GHz or 5GHz ANT0
W-AP175 Series 2.4GHz R1-1
5GHz R0-1
Installing APs on the Network
Use the AP placement map generated by RF Plan to install APs. You can either connect the AP directly to a port on
the controller, or connect the AP to another switch or router that has layer-2 or layer-3 connectivity to the controller.
If the Ethernet port on the controller is an 802.3af Power over Ethernet (PoE) port, the AP automatically uses it to
power up. If a PoE port is not available, you must get an AC adapter for the AP. For more information, see the
Installation Guide for the specific AP.
Once an AP is connected to the network and powered up, it attempts to locate the master controller using one of
the methods described in "Enabling Controller Discovery" on page 405.
