GNS 430(A) Pilot’s Guide and Reference
190-00140-00 Rev. P
10-30
SECTION 10
AUX PAGES
4) The flashing cursor moves to the minimum
runway length field (Figure 10-77). To enter
a different minimum runway length, use the
small and large right knobs to enter the
desired length. Press the ENT Key when
finished.
Figure 10-77 Minimum Runway Length Field Selected
Setup 2 Page: COM Configuration
To set the COM channel spacing:
1) Select ‘COM Configuration’ from the Setup
2 Page, using the steps described at the
beginning of this section.
2) The flashing cursor highlights the channel
spacing field (Figure 10-78). Turn the small
right knob to select the desired channel
spacing: 8.33 kHz or 25.0 kHz. Press the ENT
Key when finished.
Figure 10-78 Channel Spacing Window
Restoring Factory Settings
When making changes to any Setup 2 Page option,
a ‘Restore Defaults?’ menu selection restores the original
factory settings (for the selected option).
To restore a Setup 2 option to the original
factory settings:
1) Select the desired menu option from the
Setup 2 Page, using the steps described at the
beginning of this section.
2) Press the MENU Key to display the COM Setup
Page Menu (Figure 10-79).
Figure 10-79 COM Setup Page Menu
3) With ‘Restore Defaults?’ highlighted, press the
ENT Key.
