EN
Chapter 2: Printing Tasks 27
Loading Tray 2 (4000/4000 N)
Tray 2 is a 500-sheet tray. The optional
500-sheet tray is adjusted differently
(page 29). (Tray 2 and the optional
500-sheet tray can be interchanged in
the printer.) Tray 2 adjusts for letter, A4,
and legal sizes; these adjustments
affect printer performance.
Note
To avoid paper jams, do not load trays
while the printer is printing.
1
Pull the tray completely out of the
printer.
2
If the tray is not already set to the
desired paper size, snap the left and
right guides into place to match the
width of the paper. For A4 size
paper, slide the lock down to secure
the guide.
3
Lift the back of the rear paper guide
and slide it to the desired paper size
until it clicks into place. If the tray is
not properly adjusted, the printer
might display an error message or
paper might jam.
4
Load paper into the tray. For correct
orientation, see page 36.
5
Make sure the paper is flat in the tray
at all four corners and below the tabs
on the guides. Slide the tray back
into the printer.
The printer automatically senses the
size of paper loaded if the tray is
adjusted correctly. To print by type and
size of paper, see page 52.
Lock
