
ENWW HP Jetdirect Configuration Page Messages 69
Table 7.2 General HP Jetdirect Messages (1 of 10)
Message Description
ARP DUPLICATE IP
ADDRESS
The ARP layer has detected another node on the network
using the same IP address as the HP
Jetdirect print
server. Extended error information below this message
shows the hardware address of the other node.
BABBLE ERROR Run the power-on self-test: turn the printer off, then on
again. If the error persists, replace the HP
Jetdirect print
server. For information on replacing your HP
Jetdirect
print server, see the hardware installation guide for your
print server.
BAD BOOTP REPLY An error was detected in the BOOTP reply that the
HP
Jetdirect print server received. The BOOTP reply
either had insufficient data in the UDP datagram to contain
the minimum BOOTP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP server port (67/udp).
BAD BOOTP TAG SIZE The tagsize in a vendor specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor specified area.
BOOTP/DHCP IN
PROGRESS
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
CF ERR - ACCESS LIST
EXCEEDED
The TFTP configuration file specified too many access list
entries using the “allow:” keyword.
CF ERR - FILE
INCOMPLETE
The TFTP configuration file contained an incomplete last
line that did not end in a newline character.
CF ERR - INVALID
PARAM
A line in the TFTP configuration file contained an invalid
value for one of the parameters on that line.
CF ERR - LINE TOO
LONG
A line being processed in the TFTP configuration file was
longer than the HP
Jetdirect print server could accept.
CF ERR - MISSING
PARAM
A line in the TFTP configuration file was missing a required
parameter.
CF ERR - TRAP LIST
EXCEEDED
The TFTP configuration file specified too many trap
destination list entries using the “trap-destination:”
keyword.
CF ERR - UNKNOWN
KEYWORD
A TFTP configuration file line contained an unknown
keyword.