A SERVICE OF

logo

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
42
SECTION TWO
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Using Avery Paper Labels
Use this procedure to print on sheets of Avery paper labels.
N OTE
Before printing on Avery paper labels, make sure that the label package states the
labels are paper labels designed specifically for use with HP InkJet printers. Also,
inspect the labels to make sure that they are not sticky, wrinkled, or pulling away
from their protective backing. Only use full sheets of Avery paper labels.
1. Slide the paper width adjuster to its leftmost position.
2. Pull out the paper length adjuster.
N OTE
Make sure the card guide (used when printing on index cards and postcards) is in
the down position. (See the drawing on page 36 in the procedure Using Index
Cards and Postcards for the location of the card guide.)
3. Remove up to 25 sheets (U.S. letter or A4 size sheets) of Avery
paper labels from their packaging. Fan the edges of the label
stack to separate the pages.
4. Place the sheets of Avery paper labels, print side down, on top
of approximately 25 sheets of plain paper. Be sure the combined
stack of labels and paper does not exceed approximately
1
/
4
inch
(
1
/
2
cm) in height. Tap the short edge of the stack on a flat
surface to even the stack.
2184037
Paper Width
Adjuster
Paper Length
Adjuster