A SERVICE OF

logo

100 Removal and replacement EN
7 Release the sensor unit connector (Figure 6-29).
Note This connector is not present on the HP LaserJet 6L Pro. For that model, remove the single connector
from the DC Controller.
Figure 6-29 Paper Feed Frame removal (4 of 4)
8 Verify that all cables are clear of the frame and pull the frame straight back to remove it.
To reinstall
The Paper Feed Frame may be easier to reinstall if you place the printer on its front, so that you can
apply pressure while putting the screws back in place.
Service.book Page 100 Thursday, September 14, 2000 11:15 AM