EN Bottom assemblies 111
DC Controller
1 Remove the Printer Covers.
2 Disconnect the motor connector from the motor (Figure 6-39, callout 1).
3 Disconnect the Solenoid connector from the DC Controller (Figure 6-22, callout 1).
4 Remove the back sheet metal plate and disconnect the PS202/PS204 connector (Figure 6-29).
5 Remove the AC Cable cover and disconnect the AC Cable from the DC Controller (Figures 6-13
and 6-14).
6 Tip the printer on its top, with the front facing you.
7 Remove the (4) screws (Figure 6-40, callout 1). On some models, one of the screws is a
grounding screw. The location of the grounding screw is marked by a “star” etched into the
bottom of the DC Controller.
Note If the model being serviced has a grounding screw with a washer, make sure that the grounding screw
is replaced in the same location when reinstalling the DC Controller.
Figure 6-40 DC Controller removal (1 of 3)
1
Service.book Page 111 Thursday, September 14, 2000 11:15 AM
