A SERVICE OF

logo

Open as PDF
next previous
3. Pull to release the core adaptors (1).
4. Insert the core adaptors into the take-up reel right and left end plates and turn clockwise to secure.
When attaching printing material to the take-up reel:
●
Check the leading edge of your media. If it is not evenly cut or if it is skewed, trim the printing material.
●
Check that the media is straight when it is attached to the take-up reel, otherwise it will skew as it is
wound onto the core.
NOTE The core tube on the take-up reel must be the same width as the printing material
you are using.
ENWW Use the take-up reel 49
How do I load/unload media