Hardware options installation 50
7.
Install a fan from the option kit in fan bay 1.
8. Locate the fan 1 connector ("System board components" on page 11).
9. Remove the jumper from the fan 1 connector.
10. Connect the fan cables to the system board ("System board components" on page 11):
a. Fan 1 cable to fan 1 connector
b. Fan 2 cable to fan 2 connector
11. Install the air baffle.
12. Install the access panel (on page 22).
13. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
14. Power up the server (on page 20).
SAS or SATA hard drive option
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, hard drives, or blanks installed.
