Version 1.2 Page 49 4/22/04
For more help on one of the commands above, at the prompt type:
help bch COMMAND
baud
Sets the baud rate and communication settings for a UART.
Syntax
baud index baudrate
Parameters
index – 0 through the total number of UARTS minus one
baudrate – baud rate.
Operation
This command is used to change the speed for a UART in the system. This command works for all UARTs
visible to EFIIPOSSE. If the UART is part of PDH space and is initialized by the core firmware, this
command communicates the settings to core firmware so the UART can be initialized with the new
settings on the next boot. System default is 9600 baud.
Other Communication parameters are listed in the following table:
Communications Parameters
Parameter Value
RECEIVE_FIFO_DEPTH 1
TIMEOUT 1000000
PARITY
No parity
DATA_BITS 8
STOP_BITS 1
C0NTROL~MASK 0
boottest
Interacts with the speedy boot variable allowing it to be set appropriately.
Syntax
boottest
boottest on Displays status of all speedy boot bits
boottest off Skips all tests (for a faster boot time)
boottest [test] Displays status of a specific speedy boot bit
boottest [test] [off|on] -Set or clears a specific speedy boot bit
