User information 47
10.
Re-enter nView.
11. Go to Windows tab, identify monitors (should display 1a 1b).
Test the new setting by maximizing a window. If configured properly, the maximized window fills only
one monitor. The nView option supports other customizations in the Windows® environment as described
in the ForceWare Graphics Driver nView Desktop Manager User Guide included with the NVIDIA
graphics driver SoftPaq.
Supported USB devices
RGS supports remote USB, which allows USB devices connected to the client computer to be remotely
attached to the workstation blade. Remote USB is described in the HP RGS User Guide available at
http://www.hp.com/support/rgs_manuals (http://www.hp.com/support/rgs_manuals
). This document
also lists the client-attached USB devices which can be attached to the RGS Sender (the workstation
blade).
Synchronizing a PDA
The virtual USB port currently supports PDA synchronization operations. Before synchronizing a PDA, you
must first load your PDA synchronization software on one of your blades. Contact your administrator if the
software has not been loaded.
To synchronize your PDA:
1. Open the RGS Control Panel (Setup Mode + M).
2. Click the Advanced button.
3. Click the USB tab.
4. Select the Enable USB checkbox, and then select from the list the blade where the USB traffic will be
directed.
5. Attach the PDA cradle to one of the USB ports on the workstation blade client, then place the PDA in
the cradle.
6. Follow the PDA manufacturer instructions for synchronizing the PDA on a standard Microsoft®
Windows® XP desktop system.
Adjusting audio volume on the client and blade
The workstation blade solution provides three audio adjustments:
• Adjust volume on a specific blade—Use Microsoft® Windows® Control Panel (click Start > Control
Panel > Sounds and Audio Devices). When you adjust the audio volume on a blade using
Windows® Control Panel, the Mute button in the Microsoft® Windows® XP volume control does not
function.
• Adjust volume on multiple blades—Use the volume control and mute button on the RGS Control
Panel. Open the RGS Control Panel (Setup Mode + M). If you do not hear audio, click the Mute
button, and then move the volume slider (triangular wedge next to the mute button) to the right to
increase to volume. Adjusting the volume at the client affects all blades, and muting audio at the
client mutes all audio from the blades. This change is not shown on individual Microsoft®
Windows® XP desktops.
