Table 39 System Parameters (Thunder 9500V)
Parameter SettingsParametersWindow Names
Start AttributeSystem Startup Settings
Specify this parameter when the Thunder
9500V storage system is in the one
controller configuration.
Single Mode
Specify this parameter when the Thunder
9500V storage system is in the two
controller configuration.
NOTE: Be sure to specify that Data Share
Mode will be used.
Dual Active Mode
Do not specify this parameter.Hot Stand-By Mode
You can either specify this parameter or
omit specifying this parameter.
Delay Planned ShutdownCommon 1
You can either specify this parameter or
omit specifying this parameter.
SCSI Fibre Channel Common OptionsOPTION 1
You can either specify this parameter or
omit specifying this parameter.
SCSI Fibre Channel Common OptionsOPTION 2
Specify this parameter to Reset of occurred.Operation if the processor failure
occurs
Data Striping
Specify this parameter ON.Command Queuing ModeInquiry Setting
Keep the default parameter and do not
change.
Vendor ID
Keep the default parameter and do not
change.
Product ID
You can either specify this parameter or
omit specifying this parameter.
ROM Microcode Version
You can either specify this parameter or
omit specifying this parameter.
RAM Microcode Version
You can either specify this parameter or
omit specifying this parameter.
WEB Title
Reset/LIP ModePort Type
You can either specify this parameter or
omit specifying this parameter.
Reset/LIP Mode (Signal)
You can either specify this parameter or
omit specifying this parameter.
Reset/LIP Mode (Process)
You can either specify this parameter or
omit specifying this parameter.
LIP Reset Mode
You can either specify this parameter or
omit specifying this parameter.
RS232C Error Information Outflow
Mode
Controller Option
Set this parameter to ON.Write and verify mode
Set this parameter to Standard Mode.Host Connection Mode 1Host Connection Mode
Specify HISUP Mode.
NOTE: Do not specify any other
parameters.
Host Connection Mode 2
Thunder 9500V Storage System 139
