The media is scratched or dirty.
Clean the media, referring to the CD cleaning
of the section on 'About CDs' (page 8).
The sound skips when an MP3/WMA is being
The media is scratched or dirty.
Clean the media, referring to the CD cleaning
of the section on 'About CDs' (page 8).
of the section on 'About CDs' (page 8).
The recording condition is bad.
Record the media again or use another media.
The MP3/WMA track time isn’t displayed
There are times when it isn’t displayed
correctly according to the MP3/WMA
If the following situations, consult your
Even though the disc changer is connected, the
Disc Changer source is not ON, with "AUX EXT"
showing in the display during the Changer Mode.
The messages shown below display your
No disc magazine has been loaded in
the changer. The disc magazine is not
Load the disc magazine properly.
No disc has been loaded in the disc
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Clean the CD and load it correctly.
Nothing has been recorded on the MD.
No tracks are recorded on the MD,
The unit is malfunctioning for some reason.
Press the reset button on the unit. If
the "Error-77" code does not disappear,
consult your nearest service center.
Something is wrong with the disc
magazine. Or the unit is malfunctioning for
Check the disc magazine. And then
press the reset button on the unit. If
the "Error 99" code does not disappear,
consult your nearest service center.
The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
