ENGLISH
30
15 KG
33 lbs
max. 272 mm
1 2 3
16 17 18
✓
Chain maintenance
For a long chain life, good maintenance is very important. Chains without
X-rings should be cleaned in fireproof solvent regularly and afterwards
treated with hot grease or chain spray (e.g. Shell Advance Bio Chain).
X-ring chains on the other hand are very simple to clean. The best way is to
use lots of water, but never use brushes or cleaning liquids. After letting the
chain dry, you can use a special X-ring chain spray (e.g. Shell Advance Bio
Chain).
ƽ
WARNING
ƽ
N
O LUBRICATION IS ALLOWED TO REACH THE REAR TIRE OR THE BRAKE DISKS, OTHER-
WISE THE ROAD ADHERENCE AND THE REAR WHEEL BRAKING EFFECTS WOULD BE
STRONGLY REDUCED AND THE MOTORCYCLE COULD EASILY LOSE CONTROL
.
!
CAUTION
!
W
HEN MOUNTING THE CHAIN MASTERLINK CLIP, THE CLOSED SIDE OF THE MASTERLINK
CLIP MUST POINT IN RUNNING DIRECTION
.
Also check sprockets and chain guides for wear and replace if necessary.
Chain wear
To check the chain wear, observe the following indications:
Shift the gear into idling and pull the upper chain strand with approx. 10-15
Kilograms (33 lb) upwards (see figure). Now one can measure a space of 18
chain reels at the lower chain strand. The chain should be replaced at the
latest when a space of 272 mm (10.70 in) is measured. Chains do not
always wear off evenly, therefore repeat the measurement at different
places on the chain.
NOTE:
If you mount a new chain, the sprockets should also be replaced. New
chains wear faster if used on old used sprockets.
!
CAUTION
!
S
ECURE THE SCREWS OF THE CHAIN WHEEL BY APPLYING LOCTITE AND FASTEN THEM IN A
CROSSWISE ORDER
.
T
IGHTENING TORQUE FOR NUTS: 35 NM.
T
IGHTENING TORQUE FOR SCREWS: 50 NM.
