Introduction
The LXE MX3X Battery Multi-charger is designed to simultaneously charge five Rechargeable Lithium Ion (Li-Ion) Battery
Packs. The time required for charging is dependent upon the battery pack temperature and conditions.
The charger should be located in an area where it:
l Is well ventilated.
l Is not in high traffic areas.
l Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l Has enough clearance to allow easy access to the power port on the back of the device.
l Is protected from rain, dust or inclement weather.
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell backup batteries sealed inside the mobile device.
Quick Start
The following Quick Start instructions are abbreviated and intended to give a brief overview of the process to be followed.
1. Assemble the power supply.
2. Connect the power supply to the charger.
3. Insert a battery.
4. When batteries are charging, the setup process is complete.
Note: Store the charger and batteries when not in use in a cool, dry, protected place.
E-EQ-MX3XCHGROG-C-ARC [ 1 ] MX3X Battery Charger User Guide
