Installation
Installation
Assemble the Power Supply
Assemble the AC adapter for the MX3X Battery Multi-charger before connecting it to the charger.
The AC power supply for the multi-charger is shipped with the multi-charger. Contact your LXE representative if there is no AC
cable.
The multi-charger power supply is intended for use with the multi-charger only.
l Plug the 3-prong cable into an AC wall outlet.
l Firmly press the female end of the power cable into the male connector at the back of the multi-charger.
Setup
Prerequisite: The AC Adapter is assembled and receiving AC power.
Ensure that the location you choose for the battery charger is:
l Well ventilated.
l Is not in high traffic areas.
l Has enough clearance to allow easy access to the power port on the back of the device.
l Is protected from rain, direct sunlight, dust or inclement weather.
Place the multi-charger on a flat, horizontal, hard surface or fasten securely to stable surface using the keyhole openings on the
bottom of the multi-charger.
Do not insert battery packs until the charger has finished powering up.
l Insert the power connector into the power outlet at the back of the charger.
l AC power is now being applied to the charger and it begins to power up.
l Charge bay LED flashes while the charger enters and exits it's startup check.
l When the charge bay LEDs are not illuminated, the battery charger is ready for use.
E-EQ-MX3XCHGROG-C-ARC [ 4 ] MX3X Battery Charger User Guide
