Reducing picture disturbance
(’optimizing the modulator’)
You may experience picture disturbance if you have not used
a scart cable to connect your video recorder and TV. This is
because another TV station in your reception area may
already be using UHF-channel CH35 or 583MHz.
a Switch on the TV set and select the programme number
for the video recorder.
b Make sure that there is no cassette in the video recorder.
On the video recorder, press the STOP/EJECT ? and
the PLAY G buttons at the same time for a few seconds
until a channel frequency appears on the display. The
video recorder will then transmit a test picture on this
channel.
INSTALLATION
OPTIMIZEMODULATOR
OPTIMIZE | CH35
MODULATOR ON
CHANNEL/FREQ. CH
________________________________
TOEXIT
PRESS MENU
c In the line ’CHANNEL/FREQ.’, select ’CH’ or ’FREQ.’ using
the menu buttons P or Q .
d Select the line ’OPTIMIZE’ with the menu buttons P ; or
P = . Press the menu button P .
e When the video recorder finds a ’free’ TV channel, it will
show the channel or frequency on the small
video recorder display.
DYou can also enter the channel or frequency using
buttons 0-9 .
f Tune in the TV set to this channel or frequency.
g Confirm the channel or frequency with the OK button.
h To end, press the MENU button.
Switching off the modulator
If you cannot clear picture or sound interference, you can
switch off the built-in modulator. You should only do this if you
have connected the video recorder to the TV set with a scart
cable.
DIf you have Easy Link or NexTView, the modulator will be
switched off automatically.
a Switch on the TV set and select the programme number
for the video recorder.
b Make sure that there is no cassette in the video recorder.
Press the STOP/EJECT ? and the PLAYG buttons at
the same time for a few seconds until a channel
frequency appears on the video recorder display.
c Select the line ’MODULATOR’ on the TV screen or ’M ON’
on the video recorder display with the menu buttons
P ; or P = .
d With the menu buttons Q or P , select ’OFF’ on the
TV screen or ’MOFF’ (modulator off) on the display.
e Confirm with the OK button.
f To end, press the MENU button.
Using your video recorder remote control
with your TV set
Your video recorder remote control can transmit several
commands to TV sets of different makes.
By using the TV buttons on the panel in the middle of the
control, you can:
Sp increase or reduce the TV volume;
TV y switch off the sound;
TV m switch off the TV set; and
P p change the channel
a Point the remote control at the TV set.
18
