16
Getting Ready
Installing the Wave Expansion Board
Up to two Wave Expansion Boards (SR-JV80 series; sold separately) can be
installed in EXP-D and E Slots in the XP-30. Wave Expansion Boards contain
Wave data, as well as Patches and Rhythm Sets that use this Wave data,
which can be called directly into the temporary area and played.
■ Cautions When Installing an Wave Expansion Board
● To avoid the risk of damage to internal components that can be caused by
static electricity, please carefully observe the following whenever you
handle the board.
• Before you touch the board, always first grasp a metal object (such as
a water pipe), so you are sure that any static electricity you might
have been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid touching
any of the electronic components or connectors.
• Save the bag in which the board was originally shipped, and put the
board back into it whenever you need to store or transport it.
● Use a Philips screwdriver that is suitable for the size of the screw (a
number 2 screwdriver). If an unsuitable screwdriver is used, the head of
the screw may be stripped.
● To remove a screw, rotate the screwdriver
counter-clockwise. To tighten a screw, rotate
the screwdriver clockwise.
● When installing Wave Expansion Boards,
remove only the specified screws.
● Be careful that the screws you remove do not drop into the interior of the
XP-30.
● Do not leave the bottom cover in a detached state. Be sure to reattach it
after the Wave Expansion Boards have been installed.
● Do not touch any of the printed circuit pathways or connection terminals.
● Be careful not to cut your hand on the edge of the installation bay.
● Never use excessive force when installing a circuit board. If it doesn’t fit
properly on the first attempt, remove the board and try again.
● When circuit board installation is complete, double-check your work.
To install an optional Wave Expansion Board (SR-JV80 series; sold
separately), the unit’s bottom cover must be removed. There are two slots
(EXP-D and E) into which a board can be installed. Slots EXP-D and E
correspond to the group (XP-D and E) you need to select in order to use a
Wave, Patch or Rhythm Set from the Wave Expansion Board.
When playing a Patch or
Rhythm Set that use the
Wave data from a Wave
Expansion Board, the
appropriate Wave
Expansion Board must be
installed in the XP-30 for
the sound to play correctly.
tightenloosen
