53PERFORMANCE EDIT MODE / JOB
4: PERFORMANCE INITIALIZE
[PERFORMANCE] → [JOB] → [MENU] → 4:Initialize → [ENTER/YES]
When you want to program a totally new performance combination “from
scratch,” rather than editing an existing combination, use this function to initialize all
performance parameters.
Press [F6] if you want to initialize the entire performance combination
currently in the edit buffer, or [F7] if you only want to initialize one specific
layer. If you choose [F7], use the [CS8] slider to select the layer you want to
initialize.
Press [ENTER/YES] to begin the initialize procedure. The following confir-
mation display will appear:
Press [ENTER/YES] again to confirm that you want to go ahead with the
initialize operation (which will erase all current edited data), or press [EXIT/
NO] to cancel.
When the performance data has been initialized, “Completed!” will appear
briefly on the display, then the display will return to the mode that was en-
gaged prior to calling the performance initialize function.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
