Filter
Top Products
17 Providing power
Using power supply or auto adapter
Models SE and DL
Using power supply or auto adapter
If you obtained the optional Universal power supply
9V cable or the Auto DC Jack 12 VDC adapter from
3M, plug them into their respective power sources
and the other end into the Power jack of the
instrument. If the external power source provides
the correct voltage (8-16 VDC) and sufficient
current (300 mA minimum), it will be used in
place of the batteries if they’re installed in the
instrument.
Figure 2-8 illustrates the assembly of the Universal power supply and the plug
adapter. It slides into place by guiding it down the back cavity (opening) of the
power supply.
-
NOTE: the example is a typical adapter which may be different than the one
you are using. Mechanically, it will function similarly.
Figure 2-8: Attaching the charger adapter with the plug adapter
Connecting power supply source
1. Ensure the power supply is assembled (for universal power supply only).
2. Plug the power cord into the power jack by opening the base cover. Attach the
opposite end into the power supply (i.e., outlet/automobile jack) (as discussed
in “Hardware interfaces”, page 6.)
Figure 2-9: Base (or bottom) of SoundPro
3.
Plug the opposite end into the power supply.
B. Slide plug adapter into the crevices of base
A. Universal power supply 9V
Universal
power
supply
Auto
adapter
Power Jack