Filter
Top Products
Source 1
Tuner 1
Audio
Out
Fig. 5
4. Installing the XOi
The XOi is designed to be placed on a shelf or in a component rack. If you are
mounting the XOi with other components,you should remove the feet.
The audio sources are plugged into the four local source inputs on the back panel
of the XOi using stereo RCA cables, Fig.4
5. IR Outputs
The XOi system ships with four IRE1 IR Emitters for transferring IR data from the
keypad receivers (located under the volume button) to the IR receiver on each
piece of source equipment. There are two separated IR output sections on the back
panel. The 38KHz outputs are used for most audio sources. The exception to this is
cable and satellite boxes, which operate at a higher IR carrier frequency closer to
56Khz.It is important that the output being used for each source matches the source
input number. The outputs work individually with each source to allow independent
source control. Simply plug the IRE1 IR emitter into the appropriate IR output on the
back of the XOi and attach the flasher end over the IR receiver of the source
equipment, fig. 5
10