Filter
Top Products
equipped with MM pickup cartridge to PHONO inputs (All DJ turntable use MM pick-up cartridges).
CD players or Tape Decks and other line level instruments may be connected to these jacks as long
as the LINE LEVEL SELECTOR SWITCH (40) is in the “AUX 2” position. The red colored RCA jack
represents the right channel input and the white represents the left channel input. Input volume will
be controlled by channel two CHANNEL FADER (10). The channel SOURCE SELECTOR SWITCH
(31) must be in the "Phono 2/Aux 2" position, to monitor any source connected to these jacks.
52. CHANNEL 1: PHONO 1 INPUT/AUX 1 and LINE INPUT JACKS - The type of input must directly
reflect the selected mode of the LINE LEVEL SELECTOR SWITCH (40). Connect turntables
equipped with MM pickup cartridge to PHONO inputs (All DJ turntable use MM pick-up cartridges).
CD players or Tape Decks and other line level instruments may be connected to these jacks as
long as the LINE LEVEL SELECTOR SWITCH (40) is in the “AUX 1” position. The red colored
RCA jack represents the right channel input and the white represents the left channel input. Input
volume will be controlled by channel one CHANNEL FADER (10). The channel SOURCE SELEC-
TOR SWITCH (31) must be in the "Phono 1/Aux 1" position, to monitor any source connected to
these jacks.
53. MICROPHONE 3 CONNECTOR - This jack is used to a connect a microphone to the mixer. Con-
nect you microphone via this 1/4 inch (6.3mm) jack. This microphone will be controlled through the
channel 4 fader. The channel 4 EQ will also effect the microphone output. Be sure to flip the SOURCE
SELECTOR SWITCH (31) to the “MIC 3” position to operate this microphone’s input signal.
COMMANDER PLUS™ CONTROLS AND FUNCTIONS
©American Audio® - www.americandj.com - Commander Plus™ Instruction Manual Page 17