Filter
Top Products
REAR PANEL - CONTROLS AND FUNCTIONS
©American Audio® - www.AmericanAudio.com - Q-2422/SX User Instructions page 11
25. GND (GROUND TERMINALS) -
Connect the ground lead of the turntables with these terminals. This will reduce humming and pop-
ping noises. There are two convenient ground terminals located on the rear of the mixer.
26. AC VOLTAGE SELECTOR -
Select between 115V/50Hz or 230V/60Hz. Make sure that the selector is set to the proper voltage
you are using.
27. AC CONNECTION -
This connection is used for your detachable AC power cord. Be sure to only plug your unit in to the
recommended power supply.
28. BALANCED XLR MASTER OUTPUTS -
The Master Output includes a pair XLR BALANCED JACKS as well as a pair RCA UNBALANCED
JACKS (31). The 3-pin XLR jacks send a high current balanced output signal. These jacks should be
used when you will be driving an amp or other audio equipment with a balanced input, or whenever
you will be running a signal line greater than 15 feet.
29. LIGHT CONTROL OUTPUT -
This jack provides a preset mono audio output signal. There is no way to adjust this level, however
this level will directly reflect the output level of the CHANNEL SLIDERS (6). This buffered audio out-
put should only be used with light controllers that can accept an external audio input signal. Great
for Touch Panels and Chase Controllers.
30. PLAYER CONTROL -
These jacks are used to input 1/8" mono mini plugs from a compatible American Audio "Q" series CD
players also featuring Fader “Q” Start. This feature is used to remote control a CD player. By moving
the mixer crossfader (30) from left to right you can start and pause a "Q" series compact disc player.
In other words, when the mixer crossfader is to the left, and you move it at least 20% to the right,
any player connected to the "B" PLAYER CONTROL will begin to play. When the crossfader is to
2726 3830
33
31
32
28 29 363534 37 36
25