Filter
Top Products
jack represents the right channel input and the white represents the left channel input.
27. CHANNEL 3: LINE 3 AUX INPUT JACKS - DO NOT CONNECT TURNTABLES TO THESE JACKS!
These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level
musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be con-
nected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA
jack represents the right channel input and the white represents the left channel input.
28. REC OUT - This is a low current unbalanced output source designed for various tape and CD
recorders. The Record Out (REC OUT) level is dictated by the CHANNEL FADER LEVEL (9), it is not
influenced by the MASTER VOLUME CONTROL (4).
29. RCA MASTER OUTPUTS - The Master Output includes a pair of RCA UNBALANCED JACKS (24).
The RCA jacks send a low current unbalanced output signal.
30. BALANCED XLR MASTER OUTPUTS - The Master Output includes a pair XLR Balanced
JACKS as well as a pair RCA UNBALANCED JACKS (29)
. The 3-pin XLR jacks send a high current
balanced output signal. These jacks should be used when you will be driving an amp or other audio
equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet.
Always, use these jacks whenever possible.
31. 9V AC INPUT - Connect the included power supply to this input, or any other 9v power adapter.
32. MAIN POWER SWITCH - This is the main power ON/OFF button. An L.E.D. located on the front
of the mixer will glow green when the power is ON. Before main power is applied, be sure you have
made all connections to the mixer. Also be sure your amplifier(s) is(are) tuned off. Remember to avoid
damaging pops, the mixer should be powered on first and turned off last.
Q-D6 SRS™ Controls and Features Cont.
©American Audio® - www.americanaudio.us - Q-D6 SRS™ Instruction Manual Page 12
3334
33. HEADPHONE OUTPUT JACK - This jack is used to connect your headphones to the mixer allow-
ing you to monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ head-
phones are rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME
(5) is set to minimum before you put the headphones on.
34. MICROPHONE CONNECTOR - This jack is used to a connect a microphone to the mixer. Connect
you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIC LEVEL (17).
The bass and treble levels can also be adjusted by the built-in MICROPHONE EQ (17).