Filter
Top Products
Q-D6 SRS™ Controls and Features
1. SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to
each channel. Each channel may only be assigned one input source at a time. This switch must be in
the “phono” position for turntable operation.
2. POWER L.E.D. - This L.E.D. will glow when the power is switched on.
3. CHANNEL GAIN CONTROL - This adjustment is used to adjust an audio source signal input gain
for a channel. Never use the gain control to adjust output volume. Setting the gain level properly will
ensure a clean output signal. To properly set the gain level controls:
1. Be sure the MASTER VOLUME CONTROL (4) is set to level 4.
2. Set the CHANNEL FADER (
9) to level 8.
3. Begin playback on an audio source connected to the channel you are adjusting.
4. Use the Gain Control
(3) to adjust an average output volume of +4 dB.
5. Repeat this step for all channels
4. MASTER VOLUME CONTROL - This rotary knob is used to control the master output level (volume).
To avoid distorted output try to maintain an average output signal level +4 dB. Be sure this volume
©American Audio® - www.americanaudio.us - Q-D6 SRS™ Instruction Manual Page 7
Top Panel
1
18
19
9
8
7
6
5
4
3
2
10
11
12
17
13
14
15
16