Filter
Top Products
Q-D6 SRS™ Electrical Safety Precautions
©American Audio® - www.americanaudio.us - Q-D6 SRS™ Instruction Manual Page 3
ELECTRICAL PRECAUTIONS
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
READ INSTRUCTIONS — All the safety and operating
instructions should be read before the product is
operated.
RETAIN INSTRUCTIONS — The safety and operatin
g
instructions should be retained for future reference.
HEED WARNING
S — All warnings on the product and
in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be followed.
CLEANING
— The product should be cleaned only with
a polishing cloth or a soft dry cloth. Never clean with
furniture wax, benzine, insecticides or other volatile
liquids since they may corrode the cabinet
.
ATTACHMENTS — Do not use attachments not
recommended by the product manufacturer as they
may cause hazards.
WATER AND MOISTURE
— Do not use this product
near
water — for example, near a bathtub, wash
bowl, kitchen sink, or laundry tub; in
a wet basement;
or near a swimming pool; and the like.
ACCESSORIES
— Do not place this product on an
unstable cart, stand, tripod, bracket, or table. Th
e
product may
fall, causing serious injury to a child or
adult, and serious damage to the product. Use only
with a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold
with
the product. Any mounting of the product shoul
d
follow the manufacturer’s instructions, and should
use
a mounting accessory recommended by the
manufacturer
.
CART
— A product and cart combination should be
moved
with care. Quick stops, excessive force, and
uneven surfaces may cause the product and car
t
combination to overturn
.
VENTILATION
— Slots and openings in the cabinet are
provided for ventilation and to ensure reliabl
e
operation of the product and to protect it from
overheating, and these openings must not be
blocked or covered. The openings should never be
blocked by placing the product on
a bed, sofa, rug,
or other
similar surface. This product should not be
placed
in a built-in installation such as a bookcase or
rack unless proper ventilation
is provided or the
manufacturer’s instructions have been adhered
to.
POWER SOURCES
— This product should be operated
only from the type of power source indicated on
the
marking label. If you are not sure of the type of
power supply
to your home, consult your product
dealer or local power company.
LOCATIO
N – The appliance should be installed in a
stable location.
NONUSE PERIOD
S – The power cord of the appliance
should be unplugged from the
outlet when left un-
used for a long period of time.
GROUNDING OR POLARIZATION
• If this product is equipped with a polarized alternating
current line plug
(a plug having one blade wider than
the other),
it will fit into the outlet only one way. This
is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug
should
still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
• If this product is equipped with a three-wire
grounding type plug,
a plug having a third (grounding)
pin,
it will only fit into a grounding type power outlet.
This
is a safety feature. If you are unable to insert the
plug
into the outlet, contact your electrician to
replace your obsolete
outlet. Do not defeat the
safety purpose of the grounding type plug.
POWER-CORD PROTECTION
- Power-supply cords
should be routed so that they are not likely
to be
walked on or pinched by
items placed upon or
against them, paying particular attention
to cords at
plugs, convenience receptacles, and the point where
they exit from the product
.
OUTDOOR ANTENNA GROUNDING
— If an outside
antenna or cable system is connected to the product
,
be sure the antenna or cable system
is grounded so
as to provide some protection against voltage surges
and built-up static charges. Article 810 of the National
Electrical Code, ANSI/NFPA 70, provides informatio
n
with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding
conductors, location of antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode. See Figure
A.
LIGHTNING
— For added protection for this product
during
a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from
the
wall outlet and disconnect the antenna or cable
system. This
will prevent damage to the product
due to lightning and power-line surges.
POWER LINES
— An outside antenna system should
not be located
in the vicinity of overhead power lines
or other electric light or power circuits, or where it
can
fall into such power lines or circuits. When
installing an outside antenna system, extreme car
e
should be taken
to keep from touching such power
lines or circuits as contact with them might be
fatal.
OVERLOADING — Do not overload wall outlets,
extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
OBJECT AND LIQUID ENTRY
- Never push objects of
any kind
into this product through openings as they
may touch dangerous voltage points or short-out
parts that could result
in a fire or electric shock.
Never spill liquid of any kind on the product.
SERVICING
— Do not attempt to service this product
yourself as opening or removing covers may expose
you
to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel
.
DAMAGE REQUIRING SERVICE
- Unplug this product
from the wall outlet and refer servicing to qualifie
d
service personnel under the following conditions:
• When the power-supply cord or plug is damaged.
• If liquid has been spilled, or objects have fallen into
the product
.
• If the product has been exposed to rain or water.
• If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions as an
improper adjustment of other controls may result
in
damage and will often require extensive work by
a
qualified technician
to restore the product to its
normal operation.
• If the product has been dropped or damaged in any
way.
• When the product exhibits
a distinct change in
performance — this indicates a need for service.
REPLACEMENT PARTS
-- When replacement parts
are required, be sure the service technician has used
replacement parts specified by the manufacturer or
have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric
shock, or other hazards.
SAFETY CHECK - Upon completion of any service or
repairs
to this product, ask the service technician to
perform safety checks
to determine that the product
is in proper operating condition.
WALL OR CEILING MOUNTING
— The product should
not be mounted to a wall or ceiling.
HEAT
— The product should be situated away from heat
sources such as radiators, heat registers, stoves, or
other products (including
amplifiers) that produce
heat
.
IMPORTANT SAFETY INSTRUCTIONS
ANTENNA
LEAD IN
WIRE
GROUND
CLAM
P
ANTENNA
DISCHARGE UNI
T
(NEC SECTION 810-20)
GROUNDING CONDUCTOR
S
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
ELECTRI
C
SERVICE
EQUIPMENT
Fig.
A
NEC — NATIONAL ELECTRICAL CODE
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE THE COVER (OR BACK).
THERE ARE NO USER SERVICEABLE PARTS
INSIDE REFER SERVICE TO YOUR AUTHORIZED
AMERICAN AUDIO® SERVICE TECHNICIAN.