American Audio Q-D6 SRS Music Mixer User Manual


 
American Audio would like to thank for your purchase of this great product. For those of you that are
to impatient to read the entire user manual we have compiled these quick start instructions. We hope
that you will at least read through these instructions to familiarize yourself with the basic understand-
ing of the unit. The Q-D6 SRS is part of American Audio’s continuing evolution in audio technology.
This unit has been built and designed with the typical DJ in mind, by DJ’s. We have attempted to pro-
vide you with the most reliable product on the market by using only components made from quality
products.
MASTER LEVEL - Use this level control to set your volume output. Try never to send an output of
more than +4dB to your system. Signal at levels higher than this will start to distort and may cause
damage to your system and speakers. Remember that a distorted signal from you mixer will only be
multiplied throughout your system.
CHANNEL GAIN LEVEL - The channel trim levels are not to be used as volume controls, never use the
channel gain to set the output volume. These controls are used to aid in distortion control. Use these
control to preset your signal level before the crossfader. With your channel faders in the maximum
position, use the channel trim level to set an average output level of about +4dB on you master level
meter.
HEADPHONES - To avoid sever hearing damage, always be sure the headphone level is set to mini-
mum before plugging them in. Never put the headphone on without making sure the headphone level
is turned down.
MIC - The mic connector uses a 1/4” jack unbalanced connector. The DJ mic has an independent
volume control. When feedback occurs when using the mic, try lowering the “low” level this may
reduce the feedback. Always leave the mic level to it’s minimum level when not in use.
Q-START FEATURE - This function works in conjunction with a compatible American Audio or Ameri-
can DJ “Q”Start CD player. When used with a compatible CD player, you can use the crossfader to
start and stop the CD Player with the slide of the fader. The ON/OFF “Q ”START switch activates this
FADER “Q ”START feature.
Q-D6 SRS™ Quick start instructions
©American Audio® - www.americanaudio.us - Q-D6 SRS™ Instruction Manual Page 6
Q-D6 SRS™ Unpacking
Every Q-D6 SRS™ has been thoroughly tested and has been shipped in perfect operating condition.
Carefully check the shipping carton for damage that may have occurred during shipping. If the carton
appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment nec-
essary to operate the mixer has arrived intact. In case damage has been found or parts are missing,
please contact our toll free customer support number for further instructions, please do not return the
mixer to your dealer.