American DJ 150/RG DJ Equipment User Manual


 
©American DJ Supply® - www.americandj.com - Color 150/RG™ Instruction Manual Page 5
Color 150/RG™ Controls and Functions
REAR PANEL
18765432910
BOTTOM PANEL
11 15141312
1. Dip Switches - These switches serve two functions. In master
slave mode these switches are used to assign a specifi c head
address. In DMX mode these switches are used to assign a DMX
address to the unit. In DMX mode each switch corresponds to a
specifi c value based on binary code. See page 7 for a detailed
explanation of DMX binary code.
2. Microphone - This microphone receives external low frequencies to
trigger the unit in Sound-Active and Master/Slave mode.
3. Audio Sensitivity Knob - This adjust audio sensitivity of the inter-
nal microphone (5). Turning the sensitivity knob in the clockwise
direction will increase the sensitivity to sound. Turning the knob in
the counter clockwise direction will decrease the fi xture’s sensitivity
to sound.
4. Gobo Replacement Thumb Screw - See page 14 for Gobo replace-
ment.
5. Power Indicator - This LED will fl ash when it receives either an
audio or DMX signal.
6. MINI/C Controller Jack - This jack is for use with the optional
MINI/C Blackout controller only. Do not attempt to connect an audio
signal this jack, this will damage the PC board and void your manufac-
tures warranty!
7. XLR Output Jack - This jack is used to transmit the incoming
DMX signal to another DMX fi xture, or transmit a Master/Slave signal
to the nest Color 150/RG™ in the chain. For best results in DMX
or Master/Slave mode terminate this jack if it is the last unit in the
chain. See “Terminator” on page 7.
8. Power Cord - Connect only to a matching power outlet. Never use
this fi xture is the ground prong has been removed or broken off.
9. Fuse Holder - This housing stores the 3 amp GMA protective
fuse. Always replace with the exact same type fuse, unless other
wise instructed, by an authorized American DJ
® service technician.
10. XLR Input Jack - This jack is used to accept an incoming DMX
signal or Master/Slave signal.
©American DJ Supply® - www.americandj.com - Color 150/RG™ Instruction Manual Page 6
Color 150/RG™ Controls and Functions